Jump to content

gmut

Baller
 View Profile  See their activity

  • Posts

    230

  • Joined

  • Last visited

 Content Type 

Everything posted by gmut

  1. gmut
    Does anybody have fin settings and binding location for a 67" C1 ?
  2. gmut
    Was he on a 2024 Vapor Pro?
  3. gmut
    spot on!!!!!!!
  4. gmut
    @mlangeI don't know if your engine has knock sensors but my 5.7 pcm 2009 nautique 196 does and after going thru pretty much what you have I discovered that I needed a new knock sensor and that cured the surge problem' I have 2 knock sensors one on each side of the engine block. You have to remove them to drain the engine block. You have to make sure that the single wire lead going into each one is plugged in properly. Hope this helps.
  5. gmut
    @ColeGiacopuzziSo what would you recommend for a 67" 2023 Senate Pro? Shallow and long also?
  6. gmut
    @ColeGiacopuzzi Well Cole you are on a roll! My friend has a 2023 68" Vapor Pro. RFF skier. Where should he start with his fin and binding location? 34 mph skier with Reflex front binding.
  7. gmut
    @ColeGiacopuzzi You were spot with those fin settings for the Senate Pro. What a difference moving from deeper 2.485 shorter 6.865 to the shallower longer. it really freed the ski up. I have one more question. I use a T factor front boot and the heel is very similar to the Radar front boot heel. Should I measure the binding placement from the heel(plastic) of the front boot to the tail of the ski or the heel rubber? I think that if you are using Radar boots it is the heel(plasticc) of the front boot.
  8. gmut
    @ColeGiacopuzzi can you give me short and deep fin settings for a 69" 2022 Senate Pro and binding location. Currently skiing at 34 mph.
  9. gmut
    front binding at 30"
  10. gmut
    Ty was a very special person.I will miss him.
  11. gmut
    @FLeboeuf did you ever fix your knock sensor problem? I am having a similar issue. 3300 rpm and above check engine light comes on and display reads knock sensor see dealer. The boat runs just fine other than the check engine light coming on.
  12. gmut
    Jeff Gilbert...GREAT driver and all around great guy!!
  13. gmut
    Using ropes made by Joe Mackavich (248)-202-9129. He makes the best, most accurate ropes around. He lives in Michigan and will make custom ropes with mid loops upon request.
  14. gmut
    Awesome skiing Nate, Manon and Giannina......
  15. gmut
    Did Cale qualify for the slalom finals?
  16. gmut
    33 degrees
  17. gmut
    LaPOINTS
  18. gmut
    @UCFskier Merry Christmas to you too!!
  19. gmut
    Try it all and then get a cortisone shot! It works!!
  20. gmut
    @UCFskier the fact that you do not understand how the quote from @Ed_Johnson applies speaks volumes about you!! @aupatking could not agree more.
  21. gmut
    @Horton Eddie Roberts
  22. gmut
    @Jody_Seal what @skierjp said!! and Merry Christmas and a Very Blessed and Happy New Year!!
  23. gmut
    @Spineofgoo your logic escapes me,nevertheless,I totally agree with @escmanaze !
  24. gmut
    @escmanaze what you said! So much truth in that statement!
  25. gmut
    @jcamp is it so hard to believe that there are people out there that do not agree with YOUR point of view?
×
×
  • Create New...