JP77

Thanks for the follow up OB1. Annski I will be in touch with you soon. Appreciate it!

Heading down to Fort Lauderdale FL the beginning of December. Looking for a spot to ski. I found McGinnis but also saw information they may not be in business. Any recommendations?

Thanks for everyone's input. I am guessing the heat likely caused the issue from my ski being in the back of my truck for a long period of time. Lesson learned! Scot - Appreciate you taking the time to post this information. HUGE help.

Appreciate for the follow up. I will be buying new very soon. At this point I am looking for some insight on whether the Clear 250 is the correct lock (or if that is what most are using). I didn't think this stuff had a shelf life. It makes it tough even when buying it since you don't know how long the vendor may have it in their inventory. Would anyone mind sharing where you purchase (assuming you have not ran into the same issue)? Thanks in advance.

I bought it off a friend who may have had it awhile. So it could have been old. However I have been skiing with it for a couple months with no issue till now. Sounds like this is the right material? I am reluctant to buy more. Do you know if the material Goode sells is any different?

I recently switched over to Powershells and had an issue with the Interloc today. During my set I could feel the plate separating from the blank. After reattaching the plate I went out again and immediately the plate again came loose. After taking the plate off the blank to inspect, I notices the Interloc itself separating. The top mushroom later literally came apart from the adhesive layer, leaving the adhesive on the blank. I believe the exact material I used was 3M Dual Lock Clear Type 250. I have about 2 hours into cleaning off the adhesive using mineral spirits, a putty knife, and sanding sponge. I am about there but a little unsure why this happed and if I am using the correct Interloc. Has anyone experienced the same situation? Could this be an isolate occurrence with Type 250 and are others using it? Or should I be buying the stuff right from Goode? Any input would be extremely helpful and appreciated. Thanks, Joe

MS - Thanks for the info. I would be interested to know if anyone else is using the same or similar measurements.

I do not. I was planning on taking the numbers to a local pro shop to set up my ski.

I fairly new to the sport and looking for a little help setting up my ski. Had the ski for a number years but have not changed from the factory setting. Info on the ski: 2004 Connelly F1 67" Double Vision Bindings Skier: 175 lbs Left foot forward Just starting out so I am skiing 15 off at 32mph but hope to improve on that quickly I would appreciate anyone's help with info on setting up the ski. I know the ski is rather dated, and if this is just not the correct ski for me, I would appreciate the feedback. In meantime, I am hoping I can proper set this one up till I can make the transition. Thanks in advance JP