Last September I ordered a Strada boot right foot forward size 10. My shoe size is 9 1/2 and these boots run small. The boot was ordered direct from Radar and when asked Radar included the single plate. With the help of Intuition Liners, Vancouver BC and their customer service I was able to get the liner molded to my foot. I previously used a 2007 Approach mounted on a Radar double plate. To enable the rear boot to be mounted I ordered a rear plate from Wileys. I was only able to ski the boot about 15 sets but have been pleased. I do notice the Strada boot keeps a nice knee bend while cutting across the wakes. The boot is easy on but a little work to remove after you drop into the water because I tuck the elastic cord around the back then under the laces so it doesn't flop around. Yes, I do soap this binding and when inserting your foot must be careful not to bunch the footbed forward. I do have a continuing problem, after a couple sets I have to remove the binding, losen the screws holding the boot to the plate then rotate the boot clockwise. I have the boot and plate marked and the boot moves 1-2 degrees counterclockwise (left). I do not want to tighten the screws any tighter. Anyone else having this problem?