Administrators Horton Posted August 30, 2013 Administrators Share Posted August 30, 2013 I was going to make a rope release from a piece of old slalom rope and am not sure it that is right. Is that what the kids are doing these days? Goode ★ HO Syndicate ★ KD Skis ★ MasterCraft ★ PerfSki Radar ★ Reflex ★ S Lines ★ Stokes ★ Baller Video Coaching System Become a Supporting Member or make a One-time Donation Link to comment Share on other sites More sharing options...
Baller MattP Posted August 30, 2013 Baller Share Posted August 30, 2013 I can't beleive you asked this... Call your father, Ellie or @eleeski I see people using both these days. Depends on your preference. Rope=no mechanical parts to fail, just need a pinner who can hold your weight.. Wait you are going to do toes? Take video! Link to comment Share on other sites More sharing options...
Baller_ Jody_Seal Posted August 30, 2013 Baller_ Share Posted August 30, 2013 You can get two nice rope releases out of the 15 off section of a masterline slalom rope. two out of the 22 off section also. Come spend a weekend at TrickfagLand in SRB you will learn almost everything their is to know about trick skiing...........And maybe slalom too!! Link to comment Share on other sites More sharing options...
Baller ForrestGump Posted August 30, 2013 Baller Share Posted August 30, 2013 Go ahead and Panda yourself, JTH. Geez. Link to comment Share on other sites More sharing options...
Baller klindy Posted August 30, 2013 Baller Share Posted August 30, 2013 It needs to be approx 3' long with a sole loop on one end. I do not recommend anything longer and don't "burn/seal" the cut end. Don't loop the rope around the pylon like a slalom rope but instead pass the tail end thru the loop (creates a new loop) and the over the pylon. Thread the release rope thru the end of the trick ski rope and wrap the loose end around the pylon once only. It's super critical I make sure the ski rope loop doesn't get on the pylon side I any knots in the release rope (specifically the knot which holds the loop together). If its on the wrong side of that knot tbe rope is bound to hang up rather than slide off cleanly. Trust your release person when using a rope release. Link to comment Share on other sites More sharing options...
Baller thager Posted August 30, 2013 Baller Share Posted August 30, 2013 @Horton Talk to Sta Lo Wong. He also trick champion. Tell him Drew sent ya! Link to comment Share on other sites More sharing options...
Baller eleeski Posted August 30, 2013 Baller Share Posted August 30, 2013 Masterline Robbins release and a skilled release operator. Get some coaching from Kirk. Eric Link to comment Share on other sites More sharing options...
Baller Edbrazil Posted August 30, 2013 Baller Share Posted August 30, 2013 Let's see a nice clear photo, drawing, or short video of the rope release design/use. Link to comment Share on other sites More sharing options...
Baller GAJ0004 Posted August 31, 2013 Baller Share Posted August 31, 2013 I bring a rope release to tournaments. I have a CASAD universal release which will fit most boats 1994 and newer which I use in practice. Link to comment Share on other sites More sharing options...
TylerR Posted August 31, 2013 Share Posted August 31, 2013 @horton toe trick advice clips please. I will edit them for free and I promise to behave for 1 month after :) Link to comment Share on other sites More sharing options...
Baller BobH Posted August 31, 2015 Baller Share Posted August 31, 2015 If anyone still wants a video on using a rope release, let me know and I'll make one. I've used a rope release for at least 15 years and never had any problem using it - no jams or unintentional releases. Trickers up to 200 pounds only one wrap around the pylon. Link to comment Share on other sites More sharing options...
osuskiiershea Posted July 4, 2016 Share Posted July 4, 2016 @BobH can you make a video about how to set up a rope release please! I am interested in using one but want to make sure I do so right Link to comment Share on other sites More sharing options...
Baller_ Jody_Seal Posted July 4, 2016 Baller_ Share Posted July 4, 2016 Just remember to wrap so as that on a real quick release it does not whip the driver. I constantly have to remind some of these pin people to do so. Link to comment Share on other sites More sharing options...
Baller RazorRoss3 Posted July 4, 2016 Baller Share Posted July 4, 2016 @Jody_Seal, I had a friend who not only set it up to whip the driver but had burnt the end so it didn't fray. Which of course makes it hard as a rock when it while into you. Always keep it short enough to not hit the driver. Link to comment Share on other sites More sharing options...
Baller Edbrazil Posted July 4, 2016 Baller Share Posted July 4, 2016 Do some people have rope "thimbles" in their trick line loops? Would think it makes for a smoother release and no line-on-line wearing. Note: there are plastic (nylon) rope thimbles. Probably don't want to use metal thimbles, out of concern with dinging stuff on the boat. Link to comment Share on other sites More sharing options...
Baller Chef23 Posted July 4, 2016 Baller Share Posted July 4, 2016 I use a Robbins release. Just as safe as a rope release but more foolproof. Link to comment Share on other sites More sharing options...
Baller Chuck_Dickey Posted July 4, 2016 Baller Share Posted July 4, 2016 No thimbles. Just take the 15 off section, cut it 36" long, let the end fray (Do not seal) and slip the loop over the pylon as you would a slalom loop. Slide the loop of the trick rope over the open cut section, wrap the cut section twice around the pylon just below the shoulder of the pylon. Link to comment Share on other sites More sharing options...
Baller dchristman Posted July 4, 2016 Baller Share Posted July 4, 2016 11.16 Tricking Equipment and Definitions ... C.... A rope trick release mechanism up to 60cm (24”) may be used 24" seems a tad short. Where is that 24" measured? from the pylon to the loose end? the total rope length when not on the pylon? from the pylon to where it meets the tow line loop? Link to comment Share on other sites More sharing options...
Baller eleeski Posted July 5, 2016 Baller Share Posted July 5, 2016 @dchristman Longer ropes allow the release person to help the skier. With a short rope, the release person can't help the skier. I've never seen a rope release measured - the long ones are clearly out and there's always been a short one handy to keep things right. In practice, the longer rope is a bit more comfortable. It might be slightly more dangerous (more rope to slide out) but if you are doing it right the rope release is fairly safe. For really little kids, I'm coming to like the rope release better than the Robbins. I hold the rope with no wraps on the pylon and it lets go with very light loads. I have to swing the arm of the Robbins to get the same low load. For me, I want the Robbins. I pull so hard and so erratically that I need a wrap on the pylon and an operator holding tight. I've gotten much less smooth releases from the rope release than the Robbins. I don't notice the jerk it takes to trip the Robbins. @osuskiiershea Maybe you can get the team to get a Robbins (with the handle @osuskiiershea I'm assuming you are in college). Borrow a rope release at a tournament and copy it as a backup. Eric Link to comment Share on other sites More sharing options...
Baller dchristman Posted July 5, 2016 Baller Share Posted July 5, 2016 @eleeski It seems to me the intent of the length rule is to limit cheating. Rule 11.18B saysManipulation of the tow rope by the release person during the performance of tricks is prohibited. isn't this "no cheating" rule enough? Realistically, I'll probably end up using the Robbins release in tournaments because I am more likely to find the human component that is familiar with the Robbins onsite (I don't pack the human component) , however... The length rule is unclear to me. It is also slightly inaccurate - 60cm does not equal 24 inches. If the rule is in the book, it ought to be described as accurately as the rules for slalom rope dimensions so that if an official decides to measure, there is no room for argument. There may be a short one handy, but what if someone decides to measure your rope after your run? Link to comment Share on other sites More sharing options...
Baller ntx Posted July 7, 2016 Baller Share Posted July 7, 2016 @dchristman All the tournaments that I have attended the last five years, I have been more likely to find a reliable rope release person much sooner than anyone with experience with a Robins release. Link to comment Share on other sites More sharing options...
Baller dchristman Posted July 7, 2016 Baller Share Posted July 7, 2016 @ntx I am assuming you don't ski in the northeast... If I find someone at Lake Holly this weekend that is experienced with a legal (whatever that means) 24" rope release and is willing to release for me, I would be happy to have him or her. Link to comment Share on other sites More sharing options...
Baller Chef23 Posted July 7, 2016 Baller Share Posted July 7, 2016 @dchristman I ski in the Northeast but not in VA so I won't be at Lake Holly. I believe you will find someone familiar with a rope release. That said if you have a Robbins release I don't know why you don't use that instead. The Robbins release functionally does what a rope release does and I believe is safer and simpler to use. If someone is holding the rope in their fingers on a Robbins there is almost no way to hold someone in when they fall on toes. With the wrap of a rope release you can hold someone or the release can be a little late. I am interested to know why you would prefer rope over the Robbins. Link to comment Share on other sites More sharing options...
Baller dchristman Posted July 7, 2016 Baller Share Posted July 7, 2016 @chef23 I don't want to make this a North vs. South, East vs. West, heelside vs. onside, Miss Swiss vs. "your balls" thing. I refer you to this previous thread for background. I am willing to use whatever release I feel comfortable having someone use on me and they are comfortable using ... I am no longer considering a split pin as an option. I'm sure I could get Dave Robbins to release for me with his release if we weren't in the same division. My comfort level is currently higher with the rope release based on my prior experience with the Robbins and my weight. I'm a little guy - not a giant like Dave Robbins. This plays into @eleeski 's notion of great for little kids, but not as great for himself. I'm like an old(er) little kid. I could not imagine using a rope release for Dave Robbins... especially a 24" one with limited ability to wrap it around the pylon to get him out of the water! Link to comment Share on other sites More sharing options...
Baller Sethro Posted July 7, 2016 Baller Share Posted July 7, 2016 Does anybody have an email address for Dave Robbins they could PM to me? I bought a ski from him years ago and thought he might have another large ski sitting around for sale. Link to comment Share on other sites More sharing options...
Baller harddock Posted July 10, 2016 Baller Share Posted July 10, 2016 I have been using a KW trick release for years. My current one is removable because of a low pylon height. We use the in show skiing with multiple people on one release. They don't fail. Link to comment Share on other sites More sharing options...
Baller jcamp Posted March 28, 2018 Baller Share Posted March 28, 2018 Did anyone ever make/find a video or photos showing the rope release method? If so, please share. Thanks. Link to comment Share on other sites More sharing options...
Baller eleeski Posted March 28, 2018 Baller Share Posted March 28, 2018 @jcamp Make the rope release with 2 meters of slalom rope. Splice the rope in half by feeding the fid all the way down the rope. No knots just a loop that fits over the pylon. Make sure the ends are smooth (no burns or knots anywhere and I don't like a big fray at the end so I trim my old ones). Loop the release rope on the pylon. Put the release rope end through the trick rope end loop and pull it about 6" away from the pylon. Wrap the release rope around the pylon a couple times to get the skier up. Before toes, unwrap the rope! For light skiers, I hold the rope pinned against the pylon with one hand and hold the rest of the rope so it won't hang up on anything on the way out. For heavier skiers, I wrap the release rope 1/4 turn (1/2 turn for a big skier doing big tricks) and clamp it with my hand. Again hold the other end to assure it has a straight exit path. I find the hand clamping the rope against the pylon is much quicker and safer than hanging on to the rope. It also is a more positive connection with no movement. Wraps on the pylon give a slow inconsistent release and a painful drag even with a timely release. I will wrap it for hands as a backup but if it's critical (some hands need a release) I'll clamp it. A bit hard on the release person's hands - the Robbins is much easier on the pinner if I'm coaching all day. I'm pretty sure the length standard changed to 1m length. 24" was too short for safety. With that said, use the 24" release for little kids. It is really easy to hold them - most I won't even touch the pylon with the release and I want their rope clear fast. One last hint, make sure your trick rope has a section of thick (slalom) rope for its last loop. The thin spectra doesn't release as well off the rope release (or the Robbins!). Eric Link to comment Share on other sites More sharing options...
Baller dchristman Posted March 28, 2018 Baller Share Posted March 28, 2018 A word of caution for pylons without the flange below where you attach the rope like the older 196. The rope wrapped around the pylon can slide up and get caught against the rope at the attachment point slowing the release. My solution to that is to remember to keep my Robbins release with me if there's the possibility of skiing behind such a boat. Anybody have a no hardware solution to preventing that? Link to comment Share on other sites More sharing options...
Baller A_B Posted March 29, 2018 Baller Share Posted March 29, 2018 I’m glad I don’t have to worry about rope releases! Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now