Jump to content

G-10 Plate


scuppers
 Share

Recommended Posts

  • Baller
Mike sent some specially machined screws with a point on them. You screw them into the bottom of the boot, position everything, give the plate a little tap with a rubber hammer and the screws mark the plate perfectly. Drill them out and then you can counter bore for the stock tapered head screws or use a thing called a truss head screw. Very clean set up!
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...